Vapormed Volcano MEDIC 2 Instructions For Use Manual page 96

The dronabinol is vaporized in
the first few seconds of filling
the Valve Balloon.
However you should continue filling
the Valve Ballon (approx. 60 sec.) as
the additional air dilutes the aerosol,
which makes inhalation easier, espe-
cially for higher dosages.
When the Valve Balloon is filled, switch
off the pump by tapping the touch but-
ton pump ('AIR') again - and remove
the Balloon together with the Filling
Chamber.
To do this, grasp the Filling Chamber
Cap by the rotating knobs and unscrew
counterclockwise.
Remove Valve Balloon with Filling Chamber
6 . T H E U S E O F D R O N A B I N O L
Caution! Hot surface!
Do not touch any compo-
nents of the Filling Chamber
(except at the textured grip)
until they have cooled down
after the Valve Balloon has been filled.
Separate the Valve Balloon from the
Filling Chamber. The Valve closes au-
tomatically after separation and the
aerosol in the Valve Balloon cannot
escape.
Detach Valve Balloon from Filling Chamber
Do not leave the Filling Cham-
ber on the hot air outlet of the
VOLCANO MEDIC 2 when the heater is
switched on – except for separating
the alcohol or filling the Valve Balloon.
96