Application - Vapormed Volcano MEDIC 2 Instructions For Use Manual

7. T H E U S E O F H E M P F L O W E R S

7.3.1. Application

Place the Filling Chamber with cap on
the Hot Air Generator and screw it on
clockwise as far as it will go. Press the
touch button labeled 'HEAT' to switch
on the heater. When the actual temper-
ature corresponds to the set tempera-
ture, tighten the Valve Balloon, place it
on the Filling Chamber and let it lock
in place. For filling, the Valve Balloon
stands vertically on the Hot Air Gen-
erator. This will open the Valve.
Press the touch button labeled 'AIR'.
The Valve Balloon will now fill with the
cannabis aerosol.
Stretch Valve
Balloon tight
When the Valve Balloon is filled, switch
off the pump by tapping the touch
button labeld 'AIR' again - and remove
the Balloon together with the Filling
Chamber.
To do this, grasp the Filling Chamber
Cap by the rotating knobs and un-
screw counterclockwise.
Remove Valve Balloon with Filling Chamber
Caution! Hot surface!
Do not touch any compo-
nents of the Filling Chamber
(except at the textured grip)
until it has cooled down after
the Valve Balloon has been filled.
Separate the Valve Balloon from the
Filling Chamber. The Valve closes au-
tomatically after separation and the
aerosol in the Valve Balloon cannot
escape.
104