TABLE OF CONTENTS 1. Safety Instructions 2. Technical Specifications 3. Installation 4. How to set the unit 5. How to control the fixture 6. DMX512 Configuration 7. DMX512 Connections 8. Trouble shooting 9. Fixture Cleaning...
Page 3
1. Safety Introductions Please read the instructions carefully which includes important information about the installation, operation and maintenance. WARNING Please keep this User Manual for future consultation. If you sell the fixture to another user, be sure that they also receive this instruction booklet. Unpack and check carefully there is no transportation damage before using the fixture.
Caution There are no user serviceable parts inside the fixture. Do not open the housing or attempt any repairs yourself. In the unlikely situation, your unit may require service, please contact your nearest dealer. 2. Technical Specifications ● 9 and 11 DMX channels ●...
Page 5
④ ENTER Enter sub menu Note:(1) In about 10 seconds, if no buttons was pressed, the LED display will be off. Press any button to turn the display on again. (2)After pressing a button, all the parameters will be saved after about 2 seconds . (3)No matter what the program in which mode, once to detect the DMX or SLAVE signal, the program will jump into DMX or SLAVE mode automatically.
dISP Display forward Display reverse rPan Pan forward Pan reverse rTiL Tilt forward Tilt reverse rESt Reset 5. How to control the fixture There are two ways to control the fixture A. Universal DMX controller B. Master/Slave operation A. Universal DMX controller The fixture can be set the DMX address remotely by universal DMX controller.
Page 7
30-39 Color 3 40-49 Color 4 50-59 Color 5 60-69 Color 6 70-79 Color 7 80-89 Color 8 90-99 Color 9 100-109 Color 10 110-119 Color 11 120-129 Color 12 130-139 Color 13 140-149 Open 150-255 Color rainbow from slow to fast Open 8-15 Gobo 1...
Page 8
0-255 Pan/Tilt speed from fast to slow 0-59 No function 60-159 Auto mode 160-255 Sound mode 0-20 No function 21-100 Pan auto mode 101-200 Tilt auto mode 201-249 Pan/Tilt auto mode 250-255 Reset after 5 sec. 11 channel mode Channel Value Function 0-255...
1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin adapter-cable. 2. Connect the fixture together in a “daisy chain” by XLR plug cable from the output of the fixture to the input of the next fixture. The cable cannot be branched or split to a “Y”...
5. Check if the DMX cables run near or run alongside to high voltage cables that may cause damage or interference to DMX interface circuit. C. Some fixtures don’t respond to the easy controller 1. You may have a break in the DMX cabling. Check the LED for the response of the master/ slave mode signal.