Exhaust Blower; Convection Blower - England's Stove Works 25-CBPAH Installation & Operation Manual

Exhaust Blower Cleaning
Although the exhaust blower and blower housing
were designed to minimize ash build‐up, some fly‐ash will
still accumulate there throughout the burning season.
The amount and type of ash will depend on the type of
pellets and venting system, but generally this
accumulation will be mild. If, when cleaning the exhaust
blower, a large accumulation of fly‐ash is found, cleaning
the exhaust blower and housing should be performed
monthly or bimonthly to prevent this excess buildup.
Instructions
 Before beginning the exhaust blower cleaning procedure, be certain the unit is unplugged and
thoroughly cooled down.
 Remove the left side panel of the stove, using a 5/16" wrench or nut driver.
 Disconnect the venting system from the exhaust blower just enough that you will be able to remove
the exhaust blower from the stove.
 Once the panel is off, the exhaust blower will be clearly visible.
 Unplug the two wires which connect the stove wiring harness to the exhaust blower, using the quick
connect plugs. Disconnect the heat sensor that is mounted (with a screw) to the exhaust blower.
 Loosen the five (5)
 Lift the exhaust blower up and out of the stove. The gasket which seals the exhaust blower to the
exhaust blower tube is fragile, so take extra care when removing the blower. Even when being careful,
though, it is easy to tear this fragile gasket, and since an airtight seal is crucial here, it is best to replace
this gasket (Part # ‐ PU‐CBMG) every time the exhaust blower is removed.
 With the exhaust blower removed, use a utility vacuum to remove any ash accumulation in the exhaust
blower tube.
 Use a soft paint brush and carefully remove any ash accumulation from the inside of the exhaust
blower, and from the exhaust blower fan blade.
 Inspect the exhaust blower motor for dust accumulation and carefully remove it, ensuring that all air
cooling holes into the motor are open and free of dust deposits.
 Install the blower in the reverse order as described above. Remember to check the condition of the
exhaust blower gasket and to replace the heat sensor onto the exhaust blower.
 Reinstall the venting system and panels.
Convection Blower Cleaning
As always, be certain the stove is cool and unplugged before servicing any components within the unit.
Since the convection blower does not handle any by‐products of combustion, it does not require serious
cleaning like the exhaust blower. However, dust from the home and other debris in the air can accumulate on
the blades of the convection blower. Remove the rear panel of the unit, using a 5/16" wrench or nut driver.
The convection blower is located in the middle of the stove (see image, above). Any dust that has built up on
IMPORTANT! READ AND FOLLOW ALL INSTALLATION AND MAINTENANCE INSTRUCTIONS, INCLUDING CLEANING THE UNIT AS SPECIFIED, AND
ENGLAND'S STOVE WORKS IS NOT RESPONSIBLE FOR ANY DAMAGE OR INJURY INCURRED DUE TO NEGLECT, OR DUE TO UNSAFE INSTALLATION OR
YEARLY MAINTENANCE
5
/ " self‐drilling screws which hold the exhaust blower to the exhaust blower tube.
16
REPLACING GASKETS ANNUALLY, AND PARTS AS NEEDED.
USAGE OF THIS PRODUCT. CALL TECHNICAL SUPPORT WITH ANY QUESTIONS.
Convection
Blower
29
Exhaust
Blower