Page 2
Start by unpacking everything carefully. Make sure to cover the fl oor to prevent any damage or scratching (you can use the cardboard box for this). 2x connector Diphano cannot be held responsible if the assembly instructions are not followed properly.
Page 3
LOOSEN SCREWS The plastic screws are standard delivered attached on the module. Unscrew them on the fi rst module to get started. ATTACH CONNECTORS Attach one side of the connector onto the hole on the side of the furniture. Repeat the same action for the second connector.
Page 4
PLACE SECOND MODULE Place the second module next to the fi rst module. LOOSEN SCREWS Loosen the 2 screws on the second module a little so that you have enough space to clip the connector.
Page 5
ATTACH TO SECOND MODULE Attach the other side of both connectors onto the second module. Then tighten all screws. TURN MODULES Now your modules are connected. Tilt the furniture back to its normal position with minimum 4 persons.
Page 6
how to adjust the feet Check with a spirit level if the modules are placed level. If not, (un)screw the adjustable feet until your concept is completely level. This ensures each module can be leveled so it fi ts perfectly to the next module.
maintenance & care FABRICS Simply brush away loose dirt. Spray on a cleaning solution of water and mild soap. Use a soft bristle brush to clean and allow cleaning solution to soak into the fabric. Rinse thoroughly until all soap residue is removed and allow to air-dry. 30°...
Need help?
Do you have a question about the Sunset and is the answer not in the manual?
Questions and answers