Ibrowse Connectivity Messages - Intermec 730 User Manual

iBrowse Connectivity Messages

iBrowse User's Guide
iBrowse requires a network connection to provide real-time web browsing.
As a result, iBrowse issues network-specific messages when it has difficulty
accessing the network.
"A Wireless network is not currently available"
This message is displayed when iBrowse starts running if iBrowse is unable
to get signal strength from the 802.11 access point. Press OK to continue.
This is an informational message only. The user should move to an area
with better signal strength to allow web browsing.
"Network not found. Search again?"
This message can display on startup or when attempting to navigate a web
page. This can display even when there is full signal strength because a
connection to the access point does not guarantee a connection to the
network that is hosting the web server.
Press OK to temporarily put iBrowse on hold while it searches for a
network. If no network is found the same message is displayed again. If a
network is found, the message "A Network has been found" is displayed.
Press Cancel for iBrowse to continue as if it had a valid connection to the
network.
An issue that causes this message to display is either not having a valid IP
address or entering an invalid IP address for the gateway on the computer.
"A Network has been found. Press OK to continue."
This message is displayed after the "This device is not currently connected
to the network" message if OK was pressed to keep searching for a network
and a network was found. Press OK to continue using iBrowse.
"An IP Address has not been assigned to this device."
This message is displayed on application startup if no IP address was
assigned to the computer. Press OK for iBrowse to continue without a valid
IP address. This message may display if the computer could not be assigned
a DHCP IP address or if the computer is set up to use static IP addressing
and no IP address was entered.
21