Fisher & Paykel WH9060P4 User Manual page 44

PROBLEM
Black or grey
marks on clothes
Tangling
Washer Smells
Wet patches
on clothes
Contact a Fisher & Paykel trained and supported service technician if a problem persists.
44
TROUBLESHOOTING
POSSIBLE CAUSES
Correct amount of detergent.
Washer needs to be cleaned.
Items not sorted correctly.
Washer loaded incorrectly.
Incorrect cycle for load
type selected.
Overloaded in terms of its capacity
or the cycle selected.
Delicate items.
Not using enough detergent for the
soil level in your loads.
Clothes are slightly damp from
the steam.
Inside surfaces of the washer wet.
WHAT TO DO
Ensure the correct dose of detergent is
used for the load size and soil level. Refer to
'Detergent and softener'.
Empty the machine and complete a
cycle. Refer to 'Cleaning the
DRUM CLEAN
drum and the door'.
Separate larger items from smaller items.
Load items loosely and individually into the
washer (ie not folded).
Use the or
EASY IRON STEAM REFRESH
for items that crease easily
Refer to 'Wash cycles' for recommended
maximum load size.
Wash pantyhose, bras and any
other delicate items prone to tangling in a
mesh laundry bag.
Run a cycle.
DRUM CLEAN
Buy a better quality detergent or use a
higher dose.
Different detergents have different cleaning
chemicals, consider alternating detergents
to help remove odour.
It is normal for items to be damp after using
the , this helps remove the
STEAM REFRESH
wrinkles. Remove the item from the washer
immediately at the end of the cycle and
hang up to dry.
If there is residual water on internal surfaces
of the washer (i,e inside the door, door
gasket, drum) wipe this with a soft towel
before completing a
STEAM REFRESH
cycle
cycle.