Fisher & Paykel WH9060P4 User Manual page 41

PROBLEM
Cycle time
longer than usual
/ inaccurate
adjustment of
time remaining
during cycle
Detergent or
fabric softener
remaining in
dispenser at the
end of the cycle
Washing very
wet at the end of
the cycle
TROUBLESHOOTING
POSSIBLE CAUSES
Cycle time is approximate.
Low water pressure or flow rate.
Out of balance or oversudsing.
Washing a large load.
Selecting various options.
Dispenser drawer not properly closed
or was opened part way through
the cycle.
Dirty or blocked dispenser.
Liquid sitting at the 'Max' level
at the end of the cycle indicates
a blockage.
Dispenser over loaded
with detergent.
Composition of the powder
detergent makes it difficult
to dispense.
Cycle selected not appropriate.
Incorrect spin speed for load selected.
An out of balance load has occurred.
WHAT TO DO
Cycle time is influenced by a number of
factors. Refer to 'Wash cycles'.
Ensure that inlet hose filters are not blocked.
Recovery from out of balance or oversudsing
will extend cycle time. Refer to 'Caring for
your washer'.
Be aware that it will take longer for the
machne to fill.
Be aware that some options will extend
cycle time.
Ensure the dispenser drawer is fully closed
at the start of the cycle and remains closed
throughout the cycle.
Clean the dispenser drawer. Refer to 'Cleaning
the detergent dispenser drawer'.
Clean the fabric softener dispenser
compartment. Refer to 'Cleaning the
detergent dispenser drawer'.
Clean out remaining detergent. Refer to
'Detergent and softener'.
Dissolve detergent with water to aid
with dispensing.
Particularly short or delicate cycles have
shorter spins which can result in wetter
washing at the end of the cycle.
Select a faster spin speed.
The washer compensates for the out of
balance by using a lower spin speed, to
reduce noise and potential damage to
the product.
41