Fisher & Paykel WH9060P4 User Manual page 40

PROBLEM
Washer is
not draining
Filling
continuously
Poor rinsing
Not spinning
properly
Too many
soap suds
Small puddle of
water from under
the washer
40
TROUBLESHOOTING
POSSIBLE CAUSES
Drain hose blocked.
Pump filter blocked.
Drain hose guide higher than
1200mm above floor level.
Drain hose not connected to
standpipe, tub or spigot.
Washer is siphoning.
Incorrect detergent used.
Too much detergent used.
Load has gone out of balance.
Suds build up.
Incorrect type of detergent used.
Too much detergent used.
Inlet water pressure/flow rate too low.
Inlet hose(s) or drain hose leaking.
Lots of suds.
Dispenser compartments blocked.
Dispenser drawer not fully closed.
Damage to door seal.
WHAT TO DO
Clear the drain hose.
Clear the pump filter, refer to 'Cleaning the
pump filter'.
Lower the level of the drain hose guide.
Refer to 'Draining' in your installation guide.
Connect drain hose correctly.
Refer to 'Draining' in your installation guide.
Ensure standpipe or tub is at least 600mm
from the floor level.
Use low sudsing, front loader detergent only.
Ensure the correct dose of detergent is used
for the load size and soil level.
Refer to 'Where to put the detergent'.
Open the door and redistribute the load.
Restart the washer.
Check the amount of detergent used, reduce
if necessary.
Use low sudsing, front loader detergent only.
Refer to 'Where to put the detergent'.
Ensure the correct dose of detergent is used
for the load size and soil level. Refer to
'Where to put the detergent'.
Ensure correct inlet water pressure and flow
rate as per installation instructions.
Check inlet hose(s) and the drain hose are
correctly attached and not damaged.
Suds may have leaked and then dissolved.
Refer to 'Cleaning the detergent
dispenser drawer'.
Close dispenser drawer fully and ensure
it remains closed during the cycle.
Check seal inside door for damage.
If it sustains any damage it will need to
be replaced.