Table of Contents
Advertisement
4
Connecting optical fibers
To ensure maximum power and to avoid erroneous readings always inspect fiber end faces.
Make sure they are cleaned as detailed below before inserting into any port. Quantifi Photonics
is not responsible for damage or errors caused by bad fiber cleaning or handling.
The type of optical connectors on the Switch 1000/1100/1400 Series product can be found
printed on the front plate of the product. Joining mismatched connectors will damage the
ferrules and fibre faces.
To keep connectors clean and in good condition, Quantifi Photonics strongly recommends inspecting
them with a fiber inspection probe before connecting them. Failure to do so will result in permanent
damage to the connectors and degradation of future measurements.
Quantifi Photonics uses high quality connectors in compliance with EIA-455-21A standards.
Cleaning and connecting optical fibers
To connect the fiber-optic cable to the port:
1.
Inspect the fiber using a fiber inspection microscope. If the fiber is clean, proceed to connect it
to the desired port. If the fiber is dirty, clean it as detailed below.
2.
Clean fiber ends as follows:
a.
Gently wipe the fiber end with a lint-free swab dipped in isopropyl alcohol.
b.
Use compressed air to dry completely.
c.
Visually inspect the fiber end to ensure its cleanliness.
3.
Carefully align the connector and port to prevent the fiber end from touching the outside of the
port or rubbing against other surfaces. If the connector features a key, ensure that it is correctly
mated into the corresponding notch of the port bulkhead.
4.
Push the connector in so that the fiber-optic cable is firmly in place, thus ensuring adequate
contact. If your connector features a screw sleeve, tighten the connector enough to firmly
maintain the fiber in place. Do not over tighten, as this will damage the fiber and the port
bulkhead.
If your fiber-optic cable is not properly aligned and/or connected, you will notice large signal
.
loss and reflection
Quantifi Photonics Ltd.
Automated Optical Switch | Switch 1000/1100/1400 Series
Version
3.04
12
Advertisement
Table of Contents
