Status Leds; 1X1 & 1X4 Switch; 3.3.2 1X2 Switch; 3.3.3 Crossover Switch - Quantifi Photonics 1000 Series User Manual

Status LEDs

The Status LEDs are used to denote the operation state of the Switch 1000/1100/1400 Series products.
The definition of LED states varies between switch models as shown below.
3.3.1 1x1 & 1x4 Switch
• Blinking yellow - Indicates initialization on startup.
• All off - Indicates that the Switch product is in the PARK state (State 0).
• Solid green - Indicates which state the Switch product is routed to.
• Solid red - Indicates a Switch error. Most often this means an invalid route position.

3.3.2 1x2 Switch

• Solid green - Indicates successful initialization and communication.
• Solid red - Indicates a Switch error. Most likely an initialization error at startup.

3.3.3 Crossover Switch

The Switch XX04 is a 2x2 crossover switch. This means that it has only 2 valid states: Transmit (T) and
Cross (C).
• Solid green - Indicates which state the Switch product is in (default is T).
• Solid red - Indicates there was an error in switching states. Only 1 LED will light up.

3.3.4 Duplex Switch

The Switch XX05 is a duplex switch. This means that it has only 2 valid states: 1 and 2.
• Solid green – Indicates which state the Switch is in (default is 1).
• Blinking red - Indicates there was an error in switching states. Only 1 LED will light up.

3.3.5 1xN Switch

• Blinking yellow - Indicates initialization on startup.
• Solid green - Indicates successful initialization and communication.
• Solid red - Indicates a Switch error. Most likely an initialization error at startup.
Quantifi Photonics Ltd.
Automated Optical Switch | Switch 1000/1100/1400 Series
Version 3.04 11