Setting The Local Ip Port Number - Ingenico i6780 User Manual

Local IP
192.168.0.5

Setting the Local IP Port Number

6.4.13
If your terminal is using Ethernet, and DHCP is set to None, you will need to configure the
local IP port for the terminal to use. This is a number that is used in TCP/IP applications to
designate which application the device is communicating with.
Display
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Enter Password:
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Sys Parameters
Download Method
Download Port
Setup Port
Setup Port
Port1
Port2
Port3
Port3
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
DHCP
Local IP
Local IP Port
52
Enter the local IP address.
Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Using the stylus, tap Supervisor Menu..
Key password [2] [6] [3] [4], then press [Enter].
Tap Sys Parameters.
Tap Setup Port.
Tap Port3, Ethernet.
Tap Local IP Port.
Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port