Setting The Gateway - Ingenico i6780 User Manual

Port3
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
DHCP
Local IP
Local IP Port
Server IP
Server IP Port
IP Add Mask
IP ADD MASK
XXX.XXX.XXX.XXX
Updating

Setting the Gateway

6.4.17
If you are using Ethernet, you will need to enter the IP address of the gateway server. A
gateway is a router; it is a specific host on the network which can transmit requests from one
network to another, in this case from the Ethernet network to the Internet and back again. In
many cases, this will be the subnet with a ".1" address (i.e., 192.168.1.1).
Display
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Enter Password:
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Sys Parameters
Download Method
Download Port
Setup Port
56
Tap ▼ until you reach IP Add Mask, then tap IP
Add Mask (IP address mask or subnet mask).
Enter the subnet mask.
Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Using the stylus, tap Supervisor Menu..
Key password [2] [6] [3] [4], then press [Enter].
Tap Sys Parameters.
Tap Setup Port.
Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port