Setting The Retry Count - Ingenico i6780 User Manual

Setting the Retry Count

6.4.7
This option sets the number of times the COM port should retry communications in the event
of failure (0 to 10).
Display
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Enter Password:
Supervisor Menu
Change Password
Application File
Security
Sys Parameters
Sys Parameters
Download Method
Download Port
Setup Port
Setup Port
Port1
Port2
Port3
Port X
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
LAN Address
Retry Count
Retry Count
Old Value: 4
Enter New Value:
46
Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Using the stylus, tap Supervisor Menu.
Key password [2] [6] [3] [4], then press [Enter].
Tap Sys Parameters.
Tap Setup Port.
Select Port1 or Port2.
(By default, Port 1 = Host, Port 2 = Aux.)
Tap Retry Count.
Enter the number of times the COM port should
retry in the event of failure (0 to 10).
Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port