Setting The Secondary Dns - Ingenico i6780 User Manual

Sys Parameters
Download Method
Download Port
Setup Port
Setup Port
Port1
Port2
Port3
Port3
Interface Type
Baud Rate
Data Bits
Stop Bits
Parity
DHCP
Local IP
Local IP Port
Server IP
Server IP Port
IP Add Mask
Gateway
Primary DNS
Primary DNS
XXX.XXX.XXX.XXX
Updating...

Setting the Secondary DNS

6.4.19
If you are using Ethernet, and DHCP is set to None, you will need to enter the secondary
Domain Name Service (DNS). This is used to change Internet domain names and computer
names into IP addresses and vice versa. DNS specifications require that each domain name is
served by at least two DNS servers for redundancy, a primary and secondary.
Display
Extended Menu
Serialnum Inject
System Config
System Info
Supervisor Menu
Enter Password:
58
Tap Setup Port.
Tap Port3, Ethernet.
Tap ▼ until you reach Primary DNS, then tap
Primary DNS.
Enter the address of the Primary DNS.
Action
Restart the terminal by pressing [1] + [Cancel] +
[Enter] simultaneously; while the terminal is
starting up, press [1] + [3] simultaneously to
access the Extended Menu.
Using the stylus, tap Supervisor Menu.
Key password [2] [6] [3] [4], then press [Enter].
Chapter 6 System Parameters Menu
Section 6.4 Setting Up the Port