Rear Panel - Hall Technologies EMCEE200 User Manual

EMCEE200
HDCP Notice
In order to comply with applicable laws, HDCP protected content will not be recorded. A message will be
shown in the top left of the screen to indicate the presence of HDCP. Some computer manufacturers
insert content protection when available, regardless of the content being displayed. In order to record
non-HDCP video from these sources, the EMCEE200 will need to be told to turn off support for HDCP on
that input. This does NOT strip HDCP from protected content, but allows non-HDCP video to be recorded,
such as the computer desktop, applications, etc. The computer will be unable to play HDCP protected
content until HDCP support is re-enabled. HDCP support can be enabled or disabled via the OSD MENU,
Web, GUI, RS-232, or Telnet.

Rear Panel

1) AUDIO EMBEDDING: The EMCEE200 can embed audio from one of the HDMI Inputs, or from one
of the external line-level audio inputs.
a. TOSLINK: Digital audio input via optical TOSLINK cable.
b. STEREO: Analog L/R audio input via 3.5mm cable.
2) MIC EMBEDDING: Two microphone inputs can be mixed and embedded into the HDMI output.
a. MIC 1: Mic-level input via 3.5mm cable.
b. MIC 2: Selectable between mic-level with 48V phantom power, or line-level. Input via 3-pin
terminal block.
3) HDMI INPUTS: Up to four HDMI Inputs, at resolutions from 480p up to UHD 4K@60Hz, 4:4:4.
4) AUDIO OUTPUT: The selected audio source and embedded mic mix can be de-embedded for
connection to an external audio system if needed.
a. TOSLINK: Digital audio output via optical TOSLINK cable.
b. STEREO: Analog L/R audio output via 3.5mm cable.
c. L/R Balanced: Analog L/R balanced audio output via 5-pin terminal block.
10
1 2 3 4
© Copyright 2021 Hall Technologies, LLC