Sliding Out The Rear Mounting Brackets; Mount In 4-Point Rack - Hall Technologies KVMC-UH-8-UHD User Manual

Installation
The KVM Switch Console is designed to mount in a standard 1U 19" 4-post rack system.

Sliding out the rear mounting brackets

Remove the retaining screw from the rear mounting brackets secured in channels on both
1.
sides of the console.
Slide and remove both brackets out towards the rear as shown.
2.
Mount in 4-post Rack
The Console must be supported on all its four corners. Do not install the rack using its front panel
only.
Mount both brackets (separated from the console) to the inside rear of a standard 1U
1.
rack system using user-supplied screws.
Take the console and gently slide it into the two rear-mounted brackets in the rack and
2.
secure the console in place by inserting user-supplied screws.
Hall Technologies October 1, 2023 Page 5 of 10