Table of Contents
Advertisement
EMCEE200
4.0 SETUP
Installation Recommendations
•
The EMCEE200 includes standard 19" rack mounting ears. Alternatively, these ears can be turned
90° and installed in the middle of the EMCEE200, to provide secure surface for under-table mounting
options.
•
Keep the EMCEE200 away from heat sources and ensure adequate ventilation. Do not block any
ventilation holes.
•
Do NOT add or remove Output Cards without first removing power from the EMCEE200.
•
Connect the HDMI Inputs and Outputs using good quality cables.
•
Hall Technologies carries a line of SnugFit™ HDMI cables that provide a secure and reliable
connection: https://halltechav.com/product/chd-sf/
•
The power supply uses a locking DC power connector to prevent accidental power loss. The
connector should only be finger-tight; do not over tighten.
•
The power supply must be connected to a properly grounded outlet.
•
Test all accessories such as extension cables prior to installation in a wall or plenum space.
•
If using the HDBaseT™ expansion card, use quality CAT6A cable or better. Shielded cable is
recommended to improve performance in noisy environments.
•
Route all cables away from high voltage sources such as lighting ballasts, transformers, motors, or
AC lines. Where crossing is required, run cables perpendicular to one another to reduce signal
inductance.
•
Firmware updates may be available with future updates to add features or to improve
performance. These updates will be available on the product page of the website:
https://halltechav.com/product/emcee200/
12
© Copyright 2021 Hall Technologies, LLC
Advertisement
Table of Contents
