LEAB TS 12 User Manual page 9

LEAB Automotive GmbH
Output lead with open cable ends
To connect the open cable ends of the output lead, proceed as follows:
ü The input lead is connected.
5. Connect the red wire of the output lead (2) to the positive connection of your
plug.
6. Connect the black wire of the output lead (2) to the negative connection of your
plug.
NOTE! The green wire is not used.
7. Connect the vehicle battery to the vehicle power circuit.
ð The operating display (3) is lit green. The battery charger is ready for operation.
OR
Output lead with DIN 14690 plug
To connect the DIN plug of the output lead, proceed as follows:
ü The input lead is connected.
8. Connect the DIN plug of the output lead (2) to the your plug connection.
9. Connect the vehicle battery to the vehicle power circuit.
ð The operating display (3) is lit green. The battery charger is ready for operation.
OR
Output lead with MagCode plug
To connect the MagCode plug of the output lead, proceed as follows:
ü The input lead is connected.
10. Connect the MagCode plug of the output lead (2) to your plug connection.
11. Connect the vehicle battery to the vehicle power circuit.
ð The operating display (3) is lit green. The battery charger is ready for operation.
LEAB Automotive GmbH
3. Secure the positive cable as close as possible to the
vehicle battery with a suitable fuse.
NOTE! TS 12/12-03: 5 A.
4. Connect the black wire of the input lead (1) to the negative
terminal of the vehicle battery.
ð The input lead is connected. Now connect the output
lead according to its design.
Thorshammer 6
7 Installation
24866 Busdorf 9