Change Date And Time - BreatheSafe INPRESS TS User Manual

Controlled document: M-0002B I N P R E S S T S
Revision: B
Issue Date: 30 August 2021
C on te nt s
1 USER GUIDE
1 Key Features
2 WARNING
3 CONTROLLER APPEARANCE
4 FUNCTIONS
5 OPERATING INSTRUCTIONS
5 Enter Setup Mode
6 Change Date and Time
6 Change Pressure Setpoint
6 Change ALarm Setpoint
7 Enable / Disable Buzzer
7 Change Alarm DELAY Settings
7 Change Service Reminders
8 Calibrate Zero Sensor
8 Reset Data Log
8 Test Inputs Option
9 TECHNICAL DETAILS
9 Map of Functions
11 General Arrangement
12 Connector Pinout Details
14 Installation
15 Fan Speed Control Output
15 Mounting
15 Supply Power
15 Calibration
15 Control Override
16 Data Logging Information
20 BREATHESAFE WARRANTY
21 CONTACT US
© BREATHESAFE 2021

CHANGE DATE AND TIME

Start Up Screen > Main Screen > Settings Button > Settings Screen >
Site Access Button > Date/Time Button
Enter Setup mode and press the DATE/TIME button. Use the onscreen
UP and DOWN buttons to change the corresponding fields. When set
correctly, press the SAVE button.
• HRS = current hours
• MIN = current minutes
• MON = current month
• YR = current year
CHANGE PRESSURE SETPOINT
Start Up Screen > Main Screen > Settings Button > Settings Screen >
Site Access Button > Adjust Setpoint.
The pressure setpoint changes the pressure that the cabin will be
Controlled document:
maintained. INPRESS TS keeps a higher pressure within the cabin
compared to outside.
Issue Date:
Enter Setup mode and select ADJUST SETPOINT button. Use the
onscreen UP and DOWN buttons to change the corresponding fields.
When set correctly, press the SAVE button.
Change Date and Time
PAGE 6 www.breathe-safe.com.au
CHANGE ALARM SETPOINT
Start Up Screen > Main Screen > Settings Button > Settings Screen >
Site Access Button > Adjust Setpoint.
Alarm Setpoint changes the appointed pressure that sets the alarm
off. Low pressure can allow hazardous particals into the cab and can
occur when doors or windows are left open, or if there is an issue
with the sealing.
Enter Setup mode and select ADJUST SETPOINT button. Use the
onscreen UP and DOWN buttons to change the corresponding fields.
When set correctly, press the SAVE button.
Change Pressure and Alarm Setpoint
Delivering Innovative Climate Solutions Worldwide