BreatheSafe INPRESS TS User Manual page 17

Controlled document: M-0002B I N P R E S S T S
Revision: B
Issue Date: 30 August 2021
C on te nt s
1 USER GUIDE
SETTING UP RS232 CONNECTION
1 Key Features
2 WARNING
3 CONTROLLER APPEARANCE
4 FUNCTIONS
5 OPERATING INSTRUCTIONS
5 Enter Setup Mode
6 Change Date and Time
6 Change Pressure Setpoint
6 Change ALarm Setpoint
7 Enable / Disable Buzzer
7 Change Alarm DELAY Settings
7 Change Service Reminders
8 Calibrate Zero Sensor
8 Reset Data Log
8 Test Inputs Option
9 TECHNICAL DETAILS
9 Map of Functions
11 General Arrangement
12 Connector Pinout Details
14 Installation
15 Fan Speed Control Output
15 Mounting
15 Supply Power
15 Calibration
15 Control Override
16 Data Logging Information
20 BREATHESAFE WARRANTY
21 CONTACT US
© BREATHESAFE 2021
Plug the RS232/USB adaptor into
a free USB port on your computer.
Open up TeraTerm software.
Use the following settings in
TeraTerm:
Serial and choose the correct port
connection
Hint:
Controlled document:
From drop down menu, click
Issue Date:
on the COMxx Port that has the
"USB Serial Port" connection.
Example: COM 21
This connection may be different
in your computer.
PAGE 17 www.breathe-safe.com.au Delivering Innovative Climate Solutions Worldwide
Click OK once the correct
communication port has
been identified.
Go to SETUP and click on
Serial Port
Change the COM ports to
the following configuration:
Baud Rate: 57600
Data: 8 bit
Parity: EVEN
Stop: 2 bit
Flow Control: NONE