BreatheSafe INPRESS TS User Manual page 20

Controlled document: M-0002B I N P R E S S T S
Revision: B
Issue Date: 30 August 2021
C on te nt s
1 USER GUIDE
1 Key Features
2 WARNING
3 CONTROLLER APPEARANCE
4 FUNCTIONS
5 OPERATING INSTRUCTIONS
5 Enter Setup Mode
6 Change Date and Time
6 Change Pressure Setpoint
6 Change ALarm Setpoint
7 Enable / Disable Buzzer
7 Change Alarm DELAY Settings
7 Change Service Reminders
8 Calibrate Zero Sensor
8 Reset Data Log
8 Test Inputs Option
9 TECHNICAL DETAILS
9 Map of Functions
11 General Arrangement
12 Connector Pinout Details
14 Installation
15 Fan Speed Control Output
15 Mounting
15 Supply Power
15 Calibration
15 Control Override
16 Data Logging Information
20 BREATHESAFE WARRANTY
21 CONTACT US
© BREATHESAFE 2021
We warrant all goods to be of good material and workmanship and will replace
at our Queensland factory or designated service branch, any part proved to
be defective in workmanship or material within a period of twelve (I2) months
from the date of start-up or fifteen (I5) months from the date of despatch from
Excluded from any express warranty are costs incurred in relation to service
outside our factory or designated service branch including travelling time,
waiting time, transport costs, mechanical handling equipment and overtime
This warranty does not cover damage caused by or through the fusion of the
electric motors caused by failure of electric overload protection devices, even
Controlled document:
where such motors or devices form part of the equipment supplied by us.
Issue Date:
PAGE 20 www.breathe-safe.com.au
BREATHESAFE WARRANTY
our factory whichever occurs first.
payments required.
Delivering Innovative Climate Solutions Worldwide