Controlled document: M-0002B
I N P R E S S T S
Revision: B
Issue Date: 30 August 2021
C on te nt s
1 USER GUIDE
1 Key Features
2 WARNING
3 CONTROLLER APPEARANCE
4 FUNCTIONS
5 OPERATING INSTRUCTIONS
5 Enter Setup Mode
6 Change Date and Time
6 Change Pressure Setpoint
6 Change ALarm Setpoint
7 Enable / Disable Buzzer
7 Change Alarm DELAY Settings
7 Change Service Reminders
8 Calibrate Zero Sensor
8 Reset Data Log
8 Test Inputs Option
9 TECHNICAL DETAILS
9 Map of Functions
11 General Arrangement
12 Connector Pinout Details
14 Installation
15 Fan Speed Control Output
15 Mounting
15 Supply Power
15 Calibration
15 Control Override
16 Data Logging Information
20 BREATHESAFE WARRANTY
21 CONTACT US
© BREATHESAFE 2021
OPERATING INSTRUCTIONS
ENTER SETUP MODE
Start Up Screen > Main Screen > Settings Button > Settings Screen >
Site Access Button > Insert Pin > Site Menu
To enter the Setup mode, press SETTING button. Then enter SITE
ACESS MENU. Type in 4-number pin and press ENTER.
SETUP PARAMETERS
Placing the BreatheSafe INPRESS TS unit into Setup mode allows the
adjustment of the following parameters:
•
Time (hours/minutes/seconds)
•
Date (day/month/year)
•
Pressure alarm setpoint
•
Preferred cabin pressure
Controlled document:
•
Alarm delay / Intervals of alarm
Issue Date:
•
Calibration and system settings
•
Resetting of the data logging
•
Service reminders interval gap
•
Reset current runtime between services.
FACTORY SETTINGS
To access the factory settings, a secondary pin is required.
Factory setting parameters include:
Calibration, Zero Sensors, Default Reset, Input Test,
Log Settings.
PAGE 5
www.breathe-safe.com.au
Insert Pin
Insert Pin
Delivering Innovative Climate Solutions Worldwide