To Remove The Electrical Wiring Box Cover; Mounting The Indoor Unit; To Install The Mounting Plate; To Remove The Front Grille - Daikin FTXP71N2V1B Installer's Reference Manual

6.2.4 To remove the electrical wiring box cover

6.3 Mounting the indoor unit

In this chapter

6.3.1 To install the mounting plate

FTXP-N
Daikin room air conditioner
4P518023-14L – 2022.06
1 Remove the front grille.
2 Remove 1 screw from the electrical wiring box.
3 Open the electrical wiring box cover by pulling the protruding part on the top
of the cover.
4 Unhook the tab on the bottom and remove the electrical wiring box cover.
a
b
a
c
a Tab
b Protruding part on the top of the cover
c Screw
6.3.1

To install the mounting plate.................................................................................................................................

6.3.2 To drill a wall hole ..................................................................................................................................................
6.3.3 To remove the pipe port cover ..............................................................................................................................
1 Install the mounting plate temporarily.
2 Level the mounting plate.
3 Mark the centres of the drilling points on the wall using a tape measure.
Position the end of tape measure at symbol " ".
4 Finish the installation by securing the mounting plate on the wall using
M4×25L screws (field supply).
6 Unit installation
|
3
a
Installer reference guide
23
24
25
23