Scan Operation - Icom IC-T7H Instruction Manual

4
ADVANCED FUNCTIONS

Scan operation

D Full/programmed scan
FULL SCAN
Band
edge (e.g. 144.00)
PROGRAMMED SCAN
Band
edge
FULL SCAN: Repeatedly scans all frequencies over an entire
band (the 144 MHz band or the 430(440) MHz band).
PROGRAMMED SCAN: Repeatedly scans between two
user-programmed frequencies. Used for checking for fre-
quencies within a specified range such as repeater output fre-
quencies, etc. Four pairs of scan edges are available.
18
Band
(e.g. 148.00) edge
Scan
Jump
Scan edges Band
edge
Scan
Jump
Push [VFO] to select VFO mode.
Push [ SCAN] for 1 sec.; then, while continuing to
(BAND)
push [ SCAN], rotate the tuning dial to select the de-
(BAND)
sired scan range.
The following scan ranges are selectable:
• "ALL 144" for full scan on the 144 MHz band.
• "ALL 430" or "ALL 440" for full scan on the 430(440) MHz
band.
• "PROG 1" to "PROG 4" for one of the programmed scans.
After releasing [ SCAN] the selected scan starts.
(BAND)
To activate the previously selected scan, dial rotation is
not necessary—just push [
During scan, the following can be changed:
• Scan range using [ SCAN], with/without [DIAL].
(BAND)
• Scan direction using [DIAL].
To stop the scan, push [
(VFO)
NOTE: For programmed scan, scan edges must be pro-
grammed in advance (1A/1B are programmed by default).
Program scan edges in the same manner as regular mem-
ory channels (p. 15)
If the same frequencies are programmed into a pair of
scan edges, programmed scan edge flashes, such as
"P1," but programmed scan does not proceed.
SCAN] for 1 sec.
(BAND)
CLR].