Chinese Class A Compliance Statement; European Community Compliance Statement - IBM 3534-F08 Installation And User Manual

Chinese class A compliance statement

|
|
|
|
|

European Community compliance statement

Attention: This is a class A statement. In a domestic environment, this product
might cause radio interference in which case the user might be required to take
adequate measures.
This product is in conformity with the protection requirements of EC Council
Directive 89/336/EEC on the approximation of the laws of the Member States
relating to electromagnetic compatibility. IBM cannot accept responsibility for any
failure to satisfy the protection requirements resulting from a non-recommended
modification of the product, including the fitting of non-IBM option cards.
This product has been tested and found to comply with the limits for class A
Information Technology Equipment according to European Standard EN 55022. The
limits for class A equipment were derived for commercial and industrial
environments to provide reasonable protection against interference with licensed
communication equipment.
Attention: This is a class A product. In a domestic environment, this product may
cause radio interference in which case the user may be required to take adequate
measures.
The standards compliance label on the 3534 Model F08 contains the CE mark
which indicates that this system conforms to the provisions of the following
European Council Directives, laws, and standards:
v Electro Magnetic Compatibility (EMC) Directive 89/336/EEC and the
Complementary Directives 92/31/EEC and 93/68/EEC.
v Low Voltage Directive (LVD) 73/23/EEC and the Complementary Directive
93/68/EEC.
v EN50082-2/EN55024:1998 (European Immunity Requirements)
– EN61000-3-2
– EN61000-3-3/JEIDA (European and Japanese Harmonics Specification)
v Ring wave test
Where shielded or special cables (for example, cables fitted with ferrites) are used
in the test to make the product comply with the limits:
Properly shielded and grounded cables and connectors must be used in order to
reduce the potential for causing interference to radio and TV communications and
to other electrical or electronic equipment. Such cables and connectors are
available from IBM authorized dealers. IBM cannot accept responsibility for any
interference caused by using other than recommended cables and connectors.
57
Notices