Fisher & Paykel WM1490P Installation Manual/User Manual page 14

Completing the installation
Installation test cycle
IMPORTANT!
Do this before you wash any items in your washer. This is to check that your washer is
installed correctly and that it is functioning correctly prior to use.
Turn your washer on by pressing the 'POWER' button.
1
Select the 'Quick' or 'Super Quick' cycle. Ensure the drum is empty and the door closed.
2
Touch the button. The machine will start to fill.
3
Observe the machine for any problems (eg leaking from the hoses, excess noise
● ●
or vibrations).
The washer will beep and display any faults on the screen if there are any problems.
● ●
Refer to 'Before you call for Service' section at the back of this book.
Wait until you see water in the bottom of the drum.
4
Touch to stop the cycle, then press 'POWER' to turn the machine off.
5
Press 'POWER' again, select the 'Spin' cycle and touch
6
Check the drain hose is firmly secured to the standpipe or tub, or spigot.
● ●
Observe that the machine pumps out the water, and spins.
● ●
IMPORTANT!
If there are any problems, you must address these before proceeding with normal use.
The washer will automatically turn off at the end of the cycle if there are no problems.
12
INSTALLATION INSTRUCTIONS
.