Fisher & Paykel WM1490P Installation Manual/User Manual page 21

Press 'POWER' to activate your washer.
1
Select your wash cycle by turning the SmartTouch™ Control Dial.
2
Choose your wash options, if you wish to select options different from the default
3
options for the cycle.
Touch to start the cycle.
4
If you make an invalid selection the washer will beep at you.
● ●
When the cycle finishes, your washer will perform end of cycle beeps to alert you and
● ●
then turn off automatically.
If you wish to stop your washer at any point during a cycle, simply touch
● ●
the cycle. There may be a slight delay while the drum comes to a stop, then the door
will unlock. Under certain conditions however the door will remain locked for safety
reasons (refer to the 'Safety features' section).
If you wish to cancel or change the wash cycle once a cycle has started, simply touch
● ●
the button then select the new cycle. Touch
IMPORTANT!
For the best fabric and colour care, remove your clothes as soon as the cycle has
● ●
finished.
Failure to follow the advice in this guide may result in damage to your garments and
● ●
your expectations of wash performance may not be met.
GETTING STARTED QUICKLY
3
to restart the washer.
4
to pause
19