Download Print this page

Fisher & Paykel WM1490P Installation Manual/User Manual page 35

Front loading clothes washer

Advertisement

Options
Soak (WM1490F model only)
A soak option is available on selected wash cycles. When this option is chosen the
machine will add a one hour soak sequence, which combines periods of tumbling with
soaking to help lift stubborn stains.
If 'Soak' and 'Time Saver' are selected in the same cycle, the soak duration will be
reduced to 30 minutes.
'Soak' is not available on 'Wool', 'Drum Clean', or 'Super Quick' cycles.
Wrinkle Free (WM1490F, WM1490P and WM1480P models only)
We recommend you remove the clothes from the washer immediately after the
completion of the cycle to minimise wrinkling and creasing of items and to prevent
dye run. However, if you will not be present at the end of the wash you can select
'Wrinkle Free'.
When 'Wrinkle Free' is selected, the washer will tumble the clothes once every
15 minutes for up to 12 hours after the cycle has finished. The 'Wrinkle Free' light and
 button will flash, and the washer will beep at regular intervals to remind you to
remove your load. To remove the load during this phase, simply press the
Eco
Use the 'Eco' option to save water and energy. Selecting 'Eco' will reduce the wash
temperature slightly and alter the wash and rinse programming.
Note: this option will not be available if 'Pre Wash' has been selected.
If you wish to, you can select both the 'Pre Wash' and 'Rinse+' 'Wash Boost' options
to perform on the same cycle. Likewise, you can select 'Eco' and 'Wrinkle Free' to
perform on the same cycle. Touch the appropriate button until both options are
selected. Repeat to deselect an option.
For clothes care and performance reasons not all options may be available on some
cycles.
Add a Garment (WM1490F, WM1490P and WM1480P models only)
The 'Add a Garment' option enables you to add or remove items during the wash stage
of the cycle, under certain conditions. Once the 'Add a Garment' button is touched, the
button and time to go will flash. Wait until you hear the door unlock. Open the door
and add or remove items. Close the door and touch
a Garment' button will only operate during the wash part of the cycle and when the
temperature selected is lower than 60°C. 'Add a Garment' can be used when the total
wash volume has been reached, as your washer will drain the water to a lower level if
necessary, so the door can be opened.
WASH CYCLE OPTIONS
to restart the cycle. The 'Add
button.
33

Advertisement

loading

This manual is also suitable for:

Wm1490fWm1480pWm1280j