Change Apt/Unit - HandyTrac Key Control Installation And Operation Manual

Change APT / UNIT #
This system allows you to change the name of a Location or Item that has keys stored in the cabinet.
Abbreviate the names as much as possible. For example APT/UNIT#1 could stand for "Storage". It will
make the process go much faster and make it easier to pull keys when you need them.
1) Scan your employee badge and enter
your 4 digit PIN.
2) Enter Activity Code 02 (Change
APT/UNIT#). The system will beep, and
prompt you to enter the old unit #.
Type the APT/UNIT # you want to
change and press ENTER.
3) System will prompt you to enter new
APT/UNIT#. Type new APT/UNIT # and
press ENTER to replace APT/UNIT #.
4) The system confirms replacement is
complete. Press ENTER to replace
APT/UNIT #. Press CLEAR to change to
another activity, or press OUT to end
this session.
NOTE: If you are using Alpha letters in your APT/UNIT# names, press the "Alpha" button, type the
letter you want, and press the "Enter" button for each individual letter.
Abbreviate as much as possible. For example: storage unit 1 could be "S1".
17