Replacing Fluorescent Lamps; Led Fixture Replacement - Hussmann GSVM Installation & Operation Manual

5-2
service

REPLACING FLUORESCENT LAMPS

Fluorescent lamps have a plastic shield. When
the lamp is replaced, keep the lamp shield to
install over the new lamp.
The switch under the display lamp cover
operates both the display lamp and interior
lamps.
Remove Plastic Pins Attaching Display Lamp.
— LOCK OUT / TAG OUT —
To avoid serious injury or death from electri-
cal shock, always disconnect the electrical
power at the main disconnect when servicing
or replacing any electrical component. This
includes, but is not limited to, such items as
doors, lights, fans, heaters, and thermostats.
P/N 0545716_G

LED FIXTURE REPLACEMENT

For canopy LEDs, the protective shield is
incorporated as part of the LED fixture.
Rotate the LED fixture to release it from the
lamp holder. Shelf LED fixtures are held in
place by magnets. Pull the fixture down firmly
to release disconnect cord from receptacle on
the rear wall.
Fluorescent lamps contain mercury vapor.
Mercury exposure at high levels can harm
the brain, heart, kidneys, lungs, and
immune system of people of all ages. Do
not break or puncture fluorescent lamps.
Dispose of, or store, all fluorescent lamps
in accordance with Federal (40 CFR 273),
State, and local hazardous waste
requirements. Refer to:
http://www.epa.gov/mercury/about.htm
U.S. & Canada 1-800-922-1919 • Mexico 01 800-890-2900 • www.hussmann.com