Spantree_Fast Messages; Spantree_Vlan_Switch Messages; Storm_Control Messages - Cisco Intelligent Gigabit Ethernet Switch Module Manual

SPANTREE_FAST Messages

SPANTREE_FAST-7-PORT_FWD_UPLINK: [chars] [chars] moved to Forwarding (UplinkFast).
Explanation This message means that the listed interface has been selected as the new path to the root
switch for the listed spanning-tree instance. The first [chars] is the spanning-tree instance, and the second
[chars] is the interface.
Response No action is required.

SPANTREE_VLAN_SWITCH Messages

SPANTREE_VLAN_SW-2-MAX_INSTANCE: Platform limit of [dec] STP instances exceeded. No instance created for
[chars] (port [chars]).
Explanation This message means that the number of currently active VLAN spanning-tree instances
has reached a platform-specific limit. No additional VLAN instances will be created until the number of
existing instances drops below the platform limit. [dec] is the spanning-tree instance limit, and the first
[chars] is the smallest VLAN number of those VLANs that are unable to have STP instances created.
Response Reduce the number of currently active spanning-tree instances by either disabling some of
the currently active spanning-tree instances or deleting the VLANs associated with them. You must
manually enable the spanning trees that generate this message.

STORM_CONTROL Messages

STORM_CONTROL-2-SHUTDOWN: Storm control shut down [chars].
Explanation This message means that excessive traffic has been detected on a port that has been
configured to be shut down if a storm event is detected. [chars] is the physical interface.
Response When the source of the packet storm has been fixed, re-enable the port by using the no
shutdown interface configuration command.
38
Cisco Systems Intelligent Gigabit Ethernet Switch Module for the IBM Eserver BladeCenter System Message Guide
This section contains the spanning-tree fast-convergence message.
The section contains the per-VLAN spanning-tree-specific message.
This section contains the storm control message.