Platform_Catalyst2950 Messages; Pm Messages - Cisco Intelligent Gigabit Ethernet Switch Module Manual

PLATFORM_CAT2950-3-SYSTEM_INFO_FAILURE: The board information could not be read correctly, initialization
failed.
Explanation This message means that, during switch driver initialization, there was a failure to read the
system board information, which might occur because of an ASIC problem.
Response Find out more about the error by using the show tech-support privileged EXEC command and
by copying the error message exactly as it appears on the console or system log and entering it in the Output
Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For more information about these
online tools , see the "Error Message Traceback Reports" section on page

PLATFORM_CATALYST2950 Messages

PLATFORM_CATALYST2950-1-CRASHED: [chars]
Explanation This message means that the system is attempting to display the failure message from the
previous failure. [chars] is the failure message.
Response Find out more about the error by using the show tech-support privileged EXEC command and
by copying the error message exactly as it appears on the console or system log and entering it in the Output
Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For more information about these
online tools , see the "Error Message Traceback Reports" section on page

PM Messages

PM-2-NOMEM: Not enough memory available for [chars].
Explanation This message means that the port manager subsystem could not obtain the memory it
needed to initialize the specified operation. [chars] is the port manager operation.
Response Find out more about the error by using the show tech-support privileged EXEC command and
by copying the error message exactly as it appears on the console or system log and entering it in the Output
Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For more information about these
online tools , see the "Error Message Traceback Reports" section on page
PM-2-VLAN_ADD: Failed to add VLAN [dec] - [chars].
Explanation This message means that the software failed to add the VLAN to the VLAN Trunking
Protocol (VTP) database. [dec] is the VLAN ID, and [chars] specifies the reason for the failure.
Response Find out more about the error by using the show tech-support privileged EXEC command and
by copying the error message exactly as it appears on the console or system log and entering it in the Output
Interpreter tool. Use the Bug Toolkit to look for similar reported problems. For more information about these
online tools , see the "Error Message Traceback Reports" section on page
26
Cisco Systems Intelligent Gigabit Ethernet Switch Module for the IBM Eserver BladeCenter System Message Guide
This section contains the Catalyst 2950 low-level platform message.
This section contains the port manager messages. The port manager is a state
machine that controls all the logical and physical interfaces. All features, such as
VLANs, UDLD, and so forth, work with the port manager to provide switch functions.
9.
9.
9.
9.