Fisher & Paykel OR90SPG6 User Manual page 61

Burner parts
You can remove and clean these parts with hot soapy water or non-abrasive detergents.
Clean spills regularly before they become burnt on. Do not wash these parts
in a dishwasher.
After cleaning, check that the burners and their flame spreaders are dry before
replacing correctly.
It is very important to check that the burner flame spreader and the cap have been
correctly positioned. Failure to do so can cause serious problems.
Check that the ignitor is always clean to ensure trouble free sparking. It must be cleaned
very carefully using a toothbrush and methylated spirits.
Note: to avoid damage to the electronic ignition, do not try to light a burner without all
burner parts in place.
Replacing the burner parts
Carefully replace the burner parts as per the following illustrations.
Fit the flame spreader to the housing as shown below. Make sure the burner is not
able to rotate.
Check that:
The ignitor is always clean to ensure trouble-free sparking.
The probe is always clean to ensure correct operation of the safety valves.
The flame spreaders are clean and the holes are not clogged.
Note: both the ignitor and probe must be very carefully cleaned using a toothbrush and
methylated spirits.
Replacing the semi-rapid burners
Correct positioning of burner parts
Cap
Flame
spreader
Flame failure probe
CARE AND CLEANING
Replacing the semi-rapid burner caps
Ignitor
61