Attach The Sensor Base - PreXion PreXion3D Excelsior Service Manual

3.3

Attach the SENSOR BASE

Attach the SENSOR BASE and the mechanical stoppers to the back of the Stationary Arm.
* To attach the SENSOR BASE vertically, be sure to follow the procedure below to perform the installation.
1.
Insert the SENSOR BASE from the bottom of the mechanical stoppers, and fix it temporarily to the PILLAR
(CP5X12-I3-CM1, x2) (Screw bag M).
Mechanical stopper 1
SENSOR BASE
2.
Attach the mechanical stopper 2 and mechanical stopper 3.
When attach the mechanical stopper 2, do not attach the screw to the center of three screw holes
CP5X15-I3-CM1
(Screw bag N)
Mechanical stopper 2
<Reference> The positional relationship of the actuator and the stopper mounted on the SENSOR BASE
is shown below.
XTR-PX2-C0006-IN004
Do not attach screw here.
CP5X12-I3-CM1
Mechanical stopper 3
PN3X15-P3-CM1
(Screw bag I)
Height setting (lowermost)
Height setting (uppermost)
3-5