Adjusting The Horizontal Radiation Field - PreXion PreXion3D Excelsior Service Manual

4.3

Adjusting the Horizontal Radiation field

1.
Click "Horizontal Radiation field".
→
A screen to check the horizontal direction
of the field appears.
2.
Extend the yellow frame to the entire screen
on vertical direction, and surround a bright
area (not include a border) by the yellow frame
on horizontal direction.
< When there is no dark area >
Adjustment is unnecessary.
Click [Cancel] and proceed to "4.4 エラー! 参
照元が見つかりません。".
< When there is a dark area >
Adjustment is necessary.
Perform the following procedure.
I. Adjust the yellow frame so that only the
bright area is surrounded.
II. Click [OK] to close the screen.
III. Click [START] in the "Scanning" field
IV. After the scanner initialization is complete,
once the exposure instructions are
displayed on the screen, press the exposure
switch and irradiate X-ray beam.
V. After the scanning is complete, click
[Horizontal Radiation field].
VI. Make sure that there is no dark area, click
[Cancel] and proceed to the next work.
XTR-PX2-C0006-IN004 Ceph option
< When there is no dark area >
< When there is a dark area >
↓
4-11