Advertisement
5. Remove the printings build plate from the printer, and close the warehouse
door after taking it out
6. Use a shovel knife to remove the model from the printing build plate and place
it in a wash with sufficient alcohol (90-95%). The vat is ready for cleaning. Wipe
the printing build plate and assemble it in the original position of the printer
through locking handle，hand tighten and fix, model post-processing. And finally
the steps are performed.
Model post-processing
Note: please be sure to wear protective glasses, gloves and other protective
articles to prevent resin and leather during model post-processing. In case of skin
contact, please use soapy water to clean. If it gets into eyes, please seek medical
advice immediately. Because the stronger sunlight will be instantaneous curing
resin, please operate this step in the dark or weak ultraviolet light. Please close
the printer cabin door as soon as possible after taking out the model to prevent
49
Advertisement
