Advertisement
1.Material and print profile: select the print profile that matches the current resin
material
Print job folder name: print file name(editable)
Start slicing: click this button when you confirm in the General Slicing page that all
parameters need not be modified
2.Click [Start Slicing] and the Slicing Progress dialog box will appear. After thedialog
box disappears, the slicing file will be generated at the specified location.
5.Introduction to the printing process
Model printing process
1. Insert the USB flash drive with slice files into the printer
2. Click the [File] option on the main interface of the device, enter the "print file"
interface and click [U disk file] to select the model file print
3. During the printing process, the [Pause] button can be used to check whether
the model prints normally
4. After model printing is completed, the printing build plate will automatically
rise to the top of the printer
5. After the build plate rises to the top of the printer, please open the printer
warehouse door and hold the printing build plate with your left hand and lock it
with your right hand. After the printing build plate and the z-axis bracket shake,
the locking handle is flat with printing. Slide forward and disengage from the
z-axis bracket (see picture below)
Warning: Upon this step, you must hold the printing build plate in the hand,
otherwise it will break the printer and damage the parts.
48
Advertisement
