Advertisement
Jiangsu Ouring 3D Technology co.,Ltd
2. Manually rotate the four units hand screw on the Z-axis bracket counterclockwise
to the highest position (See below picture)
If the hand screw cannot be rotated counterclockwise, please hold the printing
build plate, loosen the locking handle and then try to rotate.
3. After the hand screw is rotated, please be sure to position each
positioning pin and the positioning hole, tighten the locking handle to
make sure that the printing build plate is not shaken.；
Warning: Do not turn the locking handle counterclockwise to prevent the
printing build plate from falling off and damaging the printer.
15
Advertisement
