Table of Contents
Advertisement
(2,2) -2- 590116A DCS DD24SU TALL installA2 USCA.indd 17/8/10 8:50:30 AM
(2,2) -2- 590116A DCS DD24SU TALL installA2 USCA.indd 17/8/10 8:50:30 AM
FINAL CHECKLIST
12
Check all parts are installed.
Ensure product is level, securely fastened to the cabinetry and opens and closes
freely. The DishDrawer® must be free to fully close with no resistance from the
cabinetry.
Ensure inlet hose to water supply has rubber washer fitted and is tightened a
further half turn after seal contact.
Ensure any knockouts or plugs in drain connection have been drilled out and
drain connection has been made.
The drain hose joiner must not support the weight of excess hose material.
Keep drain hose as fully extended as possible to prevent sagging. Any excess
length of drain hose should be kept on the DishDrawer® side of the high loop.
If using Plumbing and Drainage OPTION A, ensure the Highloop is a minimum
6" (150 mm) higher than the drain hose joiner.
Turn on the power and water supply. Then press the Power (
the DishDrawer® on. The DishDrawer® should beep and Wash Program lights
light up.
Check the spray arm is in place and free to rotate.
Spray arm
Add three cups of water into the DishDrawer®. On the Wash Program Selector
Panel press Rinse and close the drawer. Start the program by pressing the Start/
Pause (
) button.
After the Rinse program has finished, ensure machine has run and drained
correctly.
Check water supply and drainage connection for leakage.
All manuals and user guides at all-guides.com
) button to turn
TROUBLESHOOTING
13
Excessive water remaining above the filter plate, after the rinse cycle
Check for a kinked drain hose or blocked waste connection, high loop not
properly installed or drain hose not routed correctly.
No water supply
Check water is connected, turned on and the spray arm is correctly fitted and
free to rotate.
No lights come on when the drawer is opened
Ensure power is connected and is switched on. Check if Auto Power option is
on.
Water around water supply and drainage connections
Check connections, existing plumbing and hoses for leaks. Check washer and
hose clamps are correctly fitted.
If product is tipping
Ensure the product is secured to the cabinetry.
If front panels are misaligned
Check and relevel product. Check the cabinetry is square.
Drawer doesn't close properly
Ensure nothing is obstructing the drawer from closing properly eg sound
insulation, hoses or drawer latches.
If a problem occurs, consult the Troubleshooting section of the User Guide.
If after checking these points you still need assistance, please refer to the
User guide for warranty details and your nearest Authorized Service Center,
or contact us through our website, www.dcsappliances.com.
www.dcsappliances.com
590116A US CA 09.10
Advertisement
Table of Contents
