Table of Contents
Advertisement
PARTS SUPPLIED
Installation guide, template
Inlet hose (1)
and user instructions
Brackets for toe kick (2)
Plastic spacers (2)
Ø4 x 13mm screws (4)
Pre-finished toe kick (1)
Unpacking and handling
Check packaging and dishwasher for signs of transport damage. If the dishwasher is in any way damaged, do not install it. Contact the dealer the dishwasher was purchased from.
z
Disposal of packaging: some of the packaging is recyclable. Check the symbols and labels and recycle if possible.
z
Always be careful with the hoses and power cord at the back of the dishwasher. Careful handling will prevent damage and malfunction from squashing, kinking or cuts.
z
While installing the dishwasher, check the drain hose is not restricted or kinked.
z
Connections and services
Check that the power cord is long enough to reach the outlet. If it isn't, it must be replaced by a Fisher & Paykel authorised technician. Extension cords or multi-outlet power boards should not
z
be used to connect the dishwasher to the power supply.
Check that the hoses are long enough to reach the services. If a hose needs extending, ensure that the extension hose is new and of equal quality and diameter to the one already fitted.
z
Note: the drain hose should not be longer than 4m, as a longer drain hose will cause reduced performance.
The dishwasher should not be connected to a water system where the temperature exceeds 60
z
a suitable tempering valve.
The dishwasher must not be connected to an under-sink high-pressure "push-through" type hot water system, as damage to the system will result.
z
Drain hose support (1)
Moisture protection
tape (1)
Ø3.5 x 12mm screws (4)
Ø4 x25mm screws (4)
PRIOR TO INSTALLATION
TECHNICAL DATA
Technical data
Check the electrical data on the rating label (located on the left-hand side of the
dishwasher's stainless steel inner door). Should the data on the rating label be different
to those specified below, consider those on the rating label as correct.
DW60UC2 models
Capacity
15 place settings
Mains water
0.03-1 MPa
pressure
(= 0.3-10 bar)
Power voltage
220-240 V (50 Hz)
Maximum current
10 A
Draw
Power
1720-2050 W
consumption
Anti-flood protection
This dishwasher has anti-flood protection, which will shut down the incoming water
supply in the event of a leak within the machine.
o
C, or where there is no temperature control, e.g. wetback system, unless the system is fitted with
DW60UC, DW60UD6 & DW60UZ6 models
15 place settings
0.03-1 MPa
(= 0.3-10 bar)
220-240 V (50Hz)
10 A
1720-2050 W
3
Advertisement
Table of Contents
