Download Print this page
Fisher & Paykel DW60U2I1 Manual
Hide thumbs Also See for DW60U2I1:

Advertisement

Quick Links

Fault Codes
If the dishwasher malfunctions, it will display a fault code and beep. Check the following table below to see if you can
correct the fault yourself.
If the dishwasher still will not work, or shows any other fault code
1. Press and hold to turn the dishwasher off and wait a few minutes.
2. Open door to turn the dishwasher back on.
If the dishwasher still does not function and/or the problem persists, disconnect the dishwasher from the power supply,
turn the water supply off, then contact Fisher & Paykel Customer Care with the fault code information.
Fault Code &
Possible Causes
Descriptions
Drain hose is crimped or bent.
The waste water is not draining
out.
The turbidity sensor is dirty and
requires cleaning.
https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60U2I1/User_Guide_DW60U2I1/16_Fault_Codes
What to Do
Check the drain hose and straighten if needed.
Ensure that the drain hose is connected in accordance
with the installation instructions.
Gently clean the turbidity sensor with a soft brush (ie
toothbrush) to remove any buildup.
Updated: Sat, 16 May 2020 01:06:11 GMT
Powered by
1

Advertisement

loading
Need help?

Need help?

Do you have a question about the DW60U2I1 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Fisher & Paykel DW60U2I1

  • Page 1 Ensure that the drain hose is connected in accordance out. with the installation instructions. The turbidity sensor is dirty and Gently clean the turbidity sensor with a soft brush (ie requires cleaning. toothbrush) to remove any buildup. https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60U2I1/User_Guide_DW60U2I1/16_Fault_Codes Updated: Sat, 16 May 2020 01:06:11 GMT Powered by...
  • Page 2 Switch dishwasher OFF and ON again. If fault persists call Water flow error. Customer Care. Switch dishwasher OFF and ON again. If the Electronics error. fault persists call Customer Care. https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60U2I1/User_Guide_DW60U2I1/16_Fault_Codes Updated: Sat, 16 May 2020 01:06:11 GMT Powered by...
  • Page 3 Switch dishwasher OFF at the power supply. Wait a few moments and switch ON again. Motor fault. If the fault persists, turn water off and disconnect from the power supply. Call Customer Care. (DW60U6I Only) https://producthelp.fisherpaykel.com/au/Clean/Dishwashers/DW60U2I1/User_Guide_DW60U2I1/16_Fault_Codes Updated: Sat, 16 May 2020 01:06:11 GMT Powered by...