H&S HD Operator's Manual / Parts Book page 26

A. (2) one at each end of PTO at U-joint
B. One on variable drive outer upper sheave
C. One on variable drive inner lower sheave
D. One on beater drive clutch
E. One on sprocket type chain tightener - beater drive
chain
F. (2) one at each end of brace - gearbox to main
apron drive shaft.
G. (2) remote fittings for right hand and center main
apron drive shaft bushings..
H. (6) beater bearings – one at each end of each beater
(sealed bearings – DO NOT over grease)
I. One on left hand main apron drive shaft bushing
J. (4) one on each main apron rear idler sprocket
K. One on beater engage bronze yoke
L. One on rear auger drive end (sealed bearing)
M. Two on front auger end (one sealed bearing, one
bushing type)
N. One on Cross Conveyor belt tightener bracket
(Under Shield)
O. One on Cross Conveyor belt clutch control handle
(Under Shield)
G L F M C
LUBRICATION
N
O
H
K
B
D
E
-24-
A I
J
H