Table of Contents
Advertisement
Quick Links
Dual Monitor Desk Stand
Instruction Manual
SKU: STAND-TS38B
Scan the QR code with your mobile device or follow the link
for helpful videos and specifications related to this product.
https://vivo-us.com/products/stand-ts38b
GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST
help@vivo-us.com
www.vivo-us.com
Chat live with an agent!
309-278-5303
Advertisement
Table of Contents
Related Manuals for Vivo STAND-TS38B
Summary of Contents for Vivo STAND-TS38B
- Page 1 Dual Monitor Desk Stand Instruction Manual SKU: STAND-TS38B Scan the QR code with your mobile device or follow the link for helpful videos and specifications related to this product. https://vivo-us.com/products/stand-ts38b GET IN TOUCH | Monday-Friday from 7:00am-7:00pm CST help@vivo-us.com www.vivo-us.com...
- Page 2 WARNING! If you do not understand these directions, or if you have any doubts about the safety of the installation, please call a qualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation may cause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.
- Page 3 TOOLS NEEDED 22 lbs DO NOT EXCEED WEIGHT CAPACITY. (10kg) Failure to do so may result in serious injury. PER ARM Phillips Screwdriver ASSEMBLY STEPS STEP 1 Install Pole (A) to Base (B) using M5x16 Screws (S-A) and 3mm Allen Wrench (T-A).
- Page 4 STEP 2 Slide Pole Cable Clip (F) and Swivel Arm (C) onto Pole (A) and tighten with 6mm Allen Wrench (T-C). Assemble Arm Cable Clips (E) to Swivel Arm (C). STEP 3 (Option A) Flat Back Monitor Attach VESA Plates (D) to the monitors using M4x12 Thumbscrews (M-A). NOTE: Hand tighten screws to avoid stripping the plastic screw heads.
- Page 5 STEP 3 (Option B) Curved Back Monitor Attach VESA Plates (D) to the monitors using M4 Spacers (M-C) and M4x30 Screws (M-B). Tighten with a Phillips screwdriver. STEP 4 Slide the monitors with VESA Plates (D) onto the heads of Swivel Arm (C) and install Security Nuts (S-B). Make sure Security Nuts (S-B) are installed before you rotate the monitors.
- Page 6 STEP 5 Tighten the bolt on the side of the tilt joint using 5mm Allen Wrench (T-B) to fix the tilt angle. To level the monitors, remove the security nut and turn the bolt with 3mm Allen Wrench (T-A) to raise or lower the monitor.
- Page 7 STEP 6 Use 3mm Allen Wrench (T-A) to adjust joints if needed. Manage cables and store Allen Wrenches in Pole Cable Clip (G) for future use.
- Page 8 AVG. RESPONSE TIME (within office hrs) - 23% within < 15m - 38% within < 30m - 61% within < 1hr - 83% within < 2hr - 92% within < 3hr FOR MORE VIVO PRODUCTS, CHECK OUT OUR WEBSITE AT: www.vivo-us.com...
Need help?
Do you have a question about the STAND-TS38B and is the answer not in the manual?
Questions and answers