Troubleshooting; Checklist (Pci Nc Card) - Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual

6. Troubleshooting

6.1 Checklist (PCI NC Card)

If a problem occurs during setup, check the items below.
<Items to be checked after the personal computer is turned
off>
!
CAUTION
Be sure to turn off the personal computer before
confirming the items below.
1. Check that all cables are correctly connected.
2. Check that the mounted NC Card is securely inserted into the
PCI bus slot.
3. Check that the rotary switch on NC Card (CDNO) is set
up properly.
<Items to be checked after the personal computer is
turned on>
1. Check that NC System Device Driver has been
installed.
2. Check that Runtime Library has been installed.
3. Check that an NC Card number has been set properly.
4. Check that the utility and MELDASMAGIC Monitor have
been installed.
5. Check that the station number of the PCI NC Card set
on the rotary switch of NC Card is not duplicated with
that of other PCI NC Card.
If the problem is not fixed even after carrying out these steps, try operations again after turning on the
personal computer again. If the problem still remains, refer to chapter 6.3 "Troubleshooting."
Downloaded from ManualsNet.com
6.1 Checklist (PCI NC Card)
search engine
6. Troubleshooting
Refer to:
4.2 Setting Up NC Card and Device
4.2 Setting Up NC Card and Device
4.2 Setting Up NC Card and Device
Refer to:
4.2 Setting Up NC Card and Device
4.4 Setting Up Runtime Library
4.4.2 Assigning an NC Card No. of
4.5.1 Installing the Utility
4.6.1 Installing MELDASMAGIC
4.2 Setting Up NC Card and Device
75
Driver (PCI NC Card)
Driver (PCI NC Card)
Driver (PCI NC Card)
Driver (PCI NC Card)
PCI NC Card
Monitor
Driver (PCI NC Card)