System Requirements - Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual

2.2 System Requirements

Table 2.1 System Requirements
Applicable PC
CPU/clock
Memory
Hard disk capacity
Floppy disk drive unit
Pointing device
Display device
Expansion slot
Drooping characteristic of internal power
supply when PC is turned off
Applicable OS
Applicable OS, and recommended CPU/clock and memory
Applicable OS
Note: The recommended values above are standards and do not guarantee the comfortable operation of
the software you add.
Downloaded from ManualsNet.com
2.2 System Requirements
Windows95
Windows98
Windows98 Second Edition
WindowsNT4.0
Windows2000
WindowsXP
Windows95 OSR2
Windows98
Windows98 Second
Edition
Windows NT4.0
Workstation (SP3 or later)
Windows2000
WindowsXP
search engine
2. Introduction
PCI NC Card
IBM PC/AT or its compatible computer
Depends on the OS used (Refer to the table below).
Depends on the OS used (Refer to the table below).
A free space of 20 MB or more
One or more floppy disk drive of 3.5 in. and 1.44 MB
A mouse or its compatible pointing device
Display device with a resolution of 640x480 dots or more
and 256 colors or more
PCI bus (PCI bus standard 2.0
or more)
Card size: 90 x 175 mm
+3V (0.2A or more) supply needed
+5V (2.5A or more)
+12V (0.5A or more)
It must take 1 ms or more for +5V voltage to drop from
+4.5V to +4.0V.
-
-
-
CPU/clock
Pentium/100 MHz or more Pentium
/150 MHz or more recommended
Pentium/200 MHz or more Pentium
/233 MHz or more recommended
Pentium/200 MHz or more Pentium
/233 MHz or more recommended
Pentium/200 MHz or more Pentium
/233 MHz or more recommended
Pentium/300 MHz or more
Pentium/300 MHz or more
3
ISA NC Card
ISA bus
Card size: 100 x 249 mm
-
-
-
Memory
16 MB or more 24 MB
or more recommended
16 MB or more 24 MB
or more recommended
24 MB or more 32 MB
or more recommended
24 MB or more 32 MB
or more recommended
64 MB or more 128 MB
or more recommended
128 MB or more