Mounting Nc Card - Mitsubishi Electric CNC MELDASMAGIC Series Instruction Manual

4.2.2.2 Mounting NC Card

Mount NC Card according to the procedures below.
!
CAUTION
Be sure to unplug the personal computer before mounting NC Card. In case this operation is
executed with the power on, the devices may be damaged.
Set the rotary switch on NC Card.
[Procedure]
(1) Refer to the following NC Card layout, and set the rotary switch (CDNO). If there is only one NC
Card to be mounted, set 0. If there is more than one NC Card to be mounted, set the switches on
the respective NC Cards to different values.
Symbol
CF61 Connector relay board connection connector
CF10 Connector relay board connection connector
CF62
CF63
PCI
CDNO PCI NC Card station number
Downloaded from ManualsNet.com
4. Setting up MELDASMAGIC64 System
4.2 Setting Up NC Card and Device Driver (PCI Card)
HR655A card layout
CDNO
CF61
CF10
Description
PCI bus connector
search engine
Board
surface
PCI
No. of pins Factory setting
26 pins
50 pins
25
CF62
CF63
-
-
-
-
-
0