SOLTEK 75FRN2 Series Manual page 50

Series 75FRN2: 75FRN2, 75FRN2-L, 75FRN2-R, 75FRN2-RL
Boot Up NumLock
Status
Gate A20 Option
Typematic Rate Setting When Disabled, the following two items (Typematic
Typematic Rate (Chars
Typematic Delay
(Msec)
Security Option If you have set a password, select whether the
APIC Mode Allows you to enable (default) / disable the APIC
OS Select For DRAM >
Toggle between On or Off to control the state of
the NumLock key when the system boots. If On,
the numeric keypad is in numeric mode. If off, the
numeric keypad is in cursor control mode.
Gate A20 refers to the way the system addresses
memory above 1MB (extended memory). When set
to Fast, the system chipset controls Gate A20. When
set to Normal, a pin in the keyboard controller con-
trols Gate A20, Setting Gate A20 to Fast improves
system speed, particularly with OS/2 and Windows.
Rate and Typematic Delay) are irrelevant. Keystroke
repeats at a rate determined by the keyboard con-
troller in your system.
When Enabled, you can select a typematic rate and
typematic delay.
When the typematic rate setting is enabled, you can
/ Sec) select a typematic rate (the rate at which character
repeats when you hold down a key) of 6, 8, 10, 12,
15, 20, 24, or 30 characters per second.
Choices: 250; 500; 750; 1000. This option sets the
time interval for displaying the first and the second
characters. If enabled, the time interval is optional.
password is required every time the System
boots, or only when you enter setup.
The choices: System(default); Setup
(Advanced Programmable Interrupt Controller)
function. APIC mode will expand available IRQs for
the system when enabled.
Select OS2 only if you are running OS/2 operating
64MB system with greater than 64MB of RAM on your
system.
64