Table of Contents
Advertisement
Quick Links
XX103-01-00
MODEL VM5094, VM5124 AND VM5154
HIGH-RESOLUTION MONOCHROME
MONITORS
Copyright © 2002 Vicon Industries Inc. All rights reserved.
Product specifications subject to change without notice
Vicon and its logo are registered trademarks of Vicon Industries Inc.
VICON INDUSTRIES INC., 89 ARKAY DRIVE, HAUPPAUGE, NEW YORK 11788
TEL: 631-952-CCTV (2288) FAX: 631-951-CCTV (2288) TOLL FREE: 800-645-9116
24-Hour Technical Support: 800-34-VICON (800-348-4266)
UK: +44 (0) 1489 566300 INFOFAX: 800-287-1207 WEB: www.vicon-cctv.com
Vicon part number 8009-8103-01-00
Section 3 Rev 902
Advertisement
Table of Contents
Related Manuals for Vicon VM5154
Summary of Contents for Vicon VM5154
- Page 1 Copyright © 2002 Vicon Industries Inc. All rights reserved. Product specifications subject to change without notice Vicon and its logo are registered trademarks of Vicon Industries Inc. VICON INDUSTRIES INC., 89 ARKAY DRIVE, HAUPPAUGE, NEW YORK 11788 TEL: 631-952-CCTV (2288) FAX: 631-951-CCTV (2288) TOLL FREE: 800-645-9116 24-Hour Technical Support: 800-34-VICON (800-348-4266) UK: +44 (0) 1489 566300 INFOFAX: 800-287-1207 WEB: www.vicon-cctv.com...
-
Page 3: Table Of Contents
Inspection for Concealed Damage ......................2 Physical Installation..........................2 Operation............................4 Troubleshooting..........................6 Maintenance ............................6 Fuse Replacement..........................6 Shipping Instructions........................7 Coaxial Cable Recommendations ....................8 Technical Information ........................9 Contents • • iii XX103 Rev 902 VM5094/VM5124/VM5154 High-Resolution Monitors... -
Page 5: Introduction
The VM5094 has a 9-inch (230 mm) screen, the VM5124 has a 12-inch (305 mm) screen and the VM5154 has a 15-inch (381 mm) screen. These compact units are housed in a rugged yet attractively-styled cabinet with a convenient carrying handle. Both units are dual scanning (EIA and CCIR) and incorporate a universal power supply that accommodates 120 or 230 VAC. -
Page 6: Installation
Installation Unpacking and Inspection All Vicon equipment is inspected and tested before leaving the factory. It is the carrier’s responsibility to deliver the equipment in the same condition in which it left the factory. Inspection for Visible Damage Immediately inspect the cartons upon delivery. On all copies of the carrier’s freight bill, make a note of any visible damage. - Page 7 Installation with multiple monitors (Monitor N is last monitor in the system) Monitor 1 Monitor N 75 ohm switch 75 ohm switch Camera (OFF) (ON) Coaxial cable Figure 1 Typical Video Installations Installation • • 3 XX103 Rev 902 VM5094/VM5124/VM5154 High-Resolution Monitors...
-
Page 8: Operation
The switch should be set to OFF for loop-through configuration and to ON when video signal is terminated at the monitor. AC Power Cord – Provides input power to unit when plugged into an outlet of appropriate voltage. 4 • • Operation XX103 Rev 902 VM5094/VM5124/VM5154 High-Resolution Monitors... - Page 9 Figure 2 Front and Rear Panel Controls Operation • • 5 XX103 Rev 902 VM5094/VM5124/VM5154 High-Resolution Monitors...
-
Page 10: Troubleshooting
Geometric distortion of the picture to the left or right Maintenance The VM5094, VM5124 and VM5154 require no maintenance except the occasional cleaning of the cabinet and screen. Some common household aerosol sprays, cleaning agents, solvents or polishes may cause damage to the cabinet finish. -
Page 11: Shipping Instructions
Shipping Instructions Use the following procedure when returning a unit to the factory: 1. Call or write Vicon for a Return Authorization (R.A.) at one of the locations listed below. Record the name of the Vicon employee who issued the R.A. -
Page 12: Coaxial Cable Recommendations
Coaxial Cable Recommendations Caution: Careful selection of proper cable is essential to obtain the best performance from this equipment. Vicon assumes no responsibility for poor performance when cables other than those recommended, or equivalent, are installed. In all cases, coaxial cable impedance should be 75 ohms. -
Page 13: Technical Information
Power: 3-conductor removable line cord with grounding plug; a 120 VAC and 230 VAC line cord is supplied. Video In/Out: BNC. Radio Frequency Emission Rating: FCC Class A. Safety Standard: UL 2044. Technical Information • • 9 XX103 Rev 902 VM5094/VM5124/VM5154 High-Resolution Monitors... - Page 14 14° to 122° F (-10° to 50° C). Operating Humidity Range: 20 to 80% relative, noncondensing. Storage Temperature Range: -20° to 140° F (-29° to 60° C). Storage Humidity Range: 0 to 85% relative, noncondensing. 10 • • Technical Information XX103 Rev 902 VM5094/VM5124/VM5154 High-Resolution Monitors...
- Page 15 Notes Technical Information • • 11 XX103 Rev 902 VM5094/VM5124/VM5154 High-Resolution Monitors...
- Page 16 Vicon Industries Inc. Corporate Headquarters 89 Arkay Drive Hauppauge, New York 11788 631-952-CCTV (2288) 800-645-9116 Fax: 631-951-CCTV (2288) &Infofax: 800-287-1207 Vicon Europe Headquarters Brunel Way Fareham, PO15 5TX United Kingdom +44 (0) 1489 566300 Fax: +44 (0) 1489 566322 Brussels Office...
Need help?
Do you have a question about the VM5154 and is the answer not in the manual?
Questions and answers