Ssl-Proxy Context - Cisco Catalyst 6500 Series Command Reference Manual

Chapter 2 Commands for the Catalyst 6500 Series SSL Services Module

ssl-proxy context

To enter the SSL context submode and define the virtual SSL context, use the ssl-proxy context
command. Use the no form of this command to remove any commands that you have entered in the SSL
context subcommand mode from the configuration.
Syntax Description
name
Defaults The default context name is "Default."
Command Modes Global configuration
Command History Release
SSL Services Module
Release 3.1(1)
Usage Guidelines The name argument is case sensitive.
After you enter the ssl-proxy context command, the prompt changes to the following:
ssl-proxy(config-context)#
After you enter the context submode, you can use the context submode commands listed in
to configure the context services.
Table 2-10 Context Submode Commands
Command
default
description description
exit
maxconns connections
natpool name start_ip_addr
end_ip_addr netmask netmask
policy health-probe tcp
policy-name
OL-9105-01
ssl-proxy context [name]
no ssl-proxy context name
Name of the context.
Modification
Support for this command was introduced on the Catalyst 6500 series
switches.
Purpose and Guidelines
Set a command to its defaults
(Optional) Allows you to enter a short description
for this context.
Exit from context configuration mode.
(Optional) Configures the maximum number of
connections for this context. Valid values are from
1 to 65536.
Configures the NAT pool settings. See the
section on page
Configures the TCP health probe policy. See the
"policy health-probe tcp" section on page
"natpool"
2-30.
Catalyst 6500 Series Switch SSL Services Module Command Reference
Defaults
65536
2-31.
ssl-proxy context
Table 2-10
2-87